FPS

The FPS spring from 100 m/s was calibrated on rods from 363 mm e gearbox con cilindro type D (for rods 301 a 400 mm).
Of course, with shorter or longer barrels the performance will decrease or increase, so you will move on to the harder or softer calibration.
The thickness due to the spring guide and piston head bearings was not taken into consideration in the calibration process.
For this reason, given the same initial conditions, an increase in performance of approximately must be taken into account 2.5 m/s for each bearing.
The FPS spring is 100% Made in Italy and was created in collaboration with leading companies in the sector.

The FPS spring from 105 m/s was calibrated on rods from 363 mm e gearbox con cilindro type D (for rods 301 a 400 mm).
Of course, with shorter or longer barrels the performance will decrease or increase, so you will move on to the harder or softer calibration.
The thickness due to the spring guide and piston head bearings was not taken into consideration in the calibration process.
Per questa ragione a parità di condizioni iniziali si deve tenere conto di un aumento prestazionale di circa 2.5 m/s for each bearing.
The FPS spring is 100% Made in Italy and was created in collaboration with leading companies in the sector.

The FPS spring from 110 m/s was calibrated on rods from 363 mm e gearbox con cilindro type D (for rods 301 a 400 mm).
Of course, with shorter or longer barrels the performance will decrease or increase, so you will move on to the harder or softer calibration.
The thickness due to the spring guide and piston head bearings was not taken into consideration in the calibration process.
For this reason, given the same initial conditions, an increase in performance of approximately must be taken into account 2.5 m/s for each bearing.
The FPS spring is 100% Made in Italy and was created in collaboration with leading companies in the sector.

The FPS spring from 120 m/s was calibrated on rods from 363 mm e gearbox con cilindro type D (for rods 301 a 400 mm).
Of course, with shorter or longer barrels the performance will decrease or increase, so you will move on to the harder or softer calibration.
The thickness due to the spring guide and piston head bearings was not taken into consideration in the calibration process.
For this reason, given the same initial conditions, an increase in performance of approximately must be taken into account 2.5 m/s for each bearing.
The FPS spring is 100% Made in Italy and was created in collaboration with leading companies in the sector.

The FPS spring from 95 m/s was calibrated on rods from 363 mm e gearbox con cilindro type D (for rods 301 a 400 mm).
Of course, with shorter or longer barrels the performance will decrease or increase, so you will move on to the harder or softer calibration.
The thickness due to the spring guide and piston head bearings was not taken into consideration in the calibration process.
For this reason, given the same initial conditions, an increase in performance of approximately must be taken into account 2.5 m/s for each bearing.
The FPS spring is 100% Made in Italy and was created in collaboration with leading companies in the sector.