ASG springs

The FPS spring from 105 m/s was calibrated on rods from 363 mm e gearbox con cilindro type D (for rods 301 a 400 mm).
Of course, with shorter or longer barrels the performance will decrease or increase, so you will move on to the harder or softer calibration.
The thickness due to the spring guide and piston head bearings was not taken into consideration in the calibration process.
For this reason, given the same initial conditions, an increase in performance of approximately must be taken into account 2.5 m/s for each bearing.
The FPS spring is 100% Made in Italy and was created in collaboration with leading companies in the sector.

The FPS spring from 110 m/s was calibrated on rods from 363 mm e gearbox con cilindro type D (for rods 301 a 400 mm).
Of course, with shorter or longer barrels the performance will decrease or increase, so you will move on to the harder or softer calibration.
The thickness due to the spring guide and piston head bearings was not taken into consideration in the calibration process.
For this reason, given the same initial conditions, an increase in performance of approximately must be taken into account 2.5 m/s for each bearing.
The FPS spring is 100% Made in Italy and was created in collaboration with leading companies in the sector.

The FPS spring from 120 m/s was calibrated on rods from 363 mm e gearbox con cilindro type D (for rods 301 a 400 mm).
Of course, with shorter or longer barrels the performance will decrease or increase, so you will move on to the harder or softer calibration.
The thickness due to the spring guide and piston head bearings was not taken into consideration in the calibration process.
For this reason, given the same initial conditions, an increase in performance of approximately must be taken into account 2.5 m/s for each bearing.
The FPS spring is 100% Made in Italy and was created in collaboration with leading companies in the sector.

The FPS spring from 85 m/s was calibrated on rods from 363 mm e gearbox con cilindro type D (for rods 301 a 400 mm).
Of course, with shorter or longer barrels the performance will decrease or increase, so you will move on to the harder or softer calibration.
In the calibration process, the thickness due to the bearings of the spring guide and the piston head was not taken into consideration, therefore, with the same initial conditions, an increase in performance of approximately 2.5 m/s for each bearing.
The FPS spring is 100% Made in Italy and was created in collaboration with leading companies in the sector.

The FPS spring from 100 m/s has been calibrated in collaboration with Daniele Cimadoro di Terni Softair.

In the phase immediately following forming the spring is stabilized in the oven at a temperature of 400 degrees centigrade for thirty minutes in order to optimize its duration over time.

100% MADE IN ITALY
100% MORE COMPATIBLE

The FPS spring from 95 m/s has been calibrated in collaboration with Daniele Cimadoro di Terni Softair.

In the phase immediately following forming the spring is stabilized in the oven at a temperature of 400 degrees centigrade for thirty minutes in order to optimize its duration over time.

100% MADE IN ITALY
100% MORE COMPATIBLE