FPS X-Ring seal for Viton piston head (XRTP)
X-RING di tenuta per testa pistone (XRTP).
100% MADE IN ITALY
5 in stock
1,90€
5 in stock
X-RING di tenuta per testa pistone (XRTP) with quadrilobed section, during dynamic stresses they are not subject to rounding in the seat.
X-Rings have less wear than O-Rings as they require less radial precompression which translates into lower contact pressure.
A lubricant reservoir can be generated between the sealing lips.
E’ There is an optimization of the sealing effect thanks to a better pressure distribution due to the square section.
The X-Rings eliminate any negative effects due to the mold closing line, since this is located in the throat between the two lips.
100% MADE IN ITALY
| Weight | 0,015 kg |
|---|
Related products
-
FPS, ASG springs, Internal and external parts of rifles, Internal parts of rifles
FPS Spring from 95 m/s (FPS-95)
FPS, ASG springs, Internal and external parts of rifles, Internal parts of riflesFPS Spring from 95 m/s (FPS-95)
The FPS spring from 95 m/s was calibrated on rods from 363 mm e gearbox con cilindro type D (for rods 301 a 400 mm).
Of course, with shorter or longer barrels the performance will decrease or increase, so you will move on to the harder or softer calibration.
The thickness due to the spring guide and piston head bearings was not taken into consideration in the calibration process.
For this reason, given the same initial conditions, an increase in performance of approximately must be taken into account 2.5 m/s for each bearing.
The FPS spring is 100% Made in Italy and was created in collaboration with leading companies in the sector.SKU: FPS-95 -
FPS, ASG springs, Internal and external parts of rifles, Internal parts of rifles
FPS Spring from 85 m/s (FPS-85)
FPS, ASG springs, Internal and external parts of rifles, Internal parts of riflesFPS Spring from 85 m/s (FPS-85)
The FPS spring from 85 m/s was calibrated on rods from 363 mm e gearbox con cilindro type D (for rods 301 a 400 mm).
Of course, with shorter or longer barrels the performance will decrease or increase, so you will move on to the harder or softer calibration.
In the calibration process, the thickness due to the bearings of the spring guide and the piston head was not taken into consideration, therefore, with the same initial conditions, an increase in performance of approximately 2.5 m/s for each bearing.
The FPS spring is 100% Made in Italy and was created in collaboration with leading companies in the sector.SKU: FPS-85 -
Internal and external parts of rifles, Internal parts of rifles, Pistons, SHS
Lightweight ABS piston with 14 SHS metal teeth
Internal and external parts of rifles, Internal parts of rifles, Pistons, SHSLightweight ABS piston with 14 SHS metal teeth
SHS piston made of durable plastic and carbon steel. The cutouts used made it possible to reduce its weight. The piston has 14 steel teeth, which make it perfect for combining with High Torque gears. This piston can easily be used for tuning replicas.
SKU: SHS-08-001521
