Transformers Decepticons 50° rubber for VSR-10 & GBB Maple Leaf
Out of stock
8,90€
Out of stock
Brand new silicone material, resistant to frost and cold
It can avoid the low temperature when gasifying the GBB gas gun and affect the HOP effect
No cold shooting effect (Cold Bore), the friction between the first shot and subsequent shots is more stable, suitable for use with a portable sniper rifle, improving the first shot success rate
Single point directional briquette, dedicated to precision shooting
Maintain the airtight design of the stainless steel C-ring, the player can choose whether to install it based on gun type or needs
Added left and right support blocks
For WE pistols and rifles / Marui / KJ / VFC (NEW GEN) GBB
Compatible with the Maple Leaf GBB series precision internal barrel
Anti-freeze silicone material
Steel C-ring included for an airtight seal. Optional installation.
50 degrees: until 360 FPS
| Weight | 0,02 kg |
|---|
Related products
-
AT COST, External parts of rifles, Internal and external parts of rifles, Slides and slide covers, Vector Optics
Medium 20mm metal support -4 Slot- Vector Optics
AT COST, External parts of rifles, Internal and external parts of rifles, Slides and slide covers, Vector OpticsMedium 20mm metal support -4 Slot- Vector Optics
metal support for weaver sled,useful for lifting red dots/optics from the slides of the replicas, height: 0,83 inches, ideale per magnifier 3x
SKU: VEC-10-030050 -
FPS, ASG springs, Internal and external parts of rifles, Internal parts of rifles
FPS Spring from 95 m/s (FPS-95)
FPS, ASG springs, Internal and external parts of rifles, Internal parts of riflesFPS Spring from 95 m/s (FPS-95)
The FPS spring from 95 m/s was calibrated on rods from 363 mm e gearbox con cilindro type D (for rods 301 a 400 mm).
Of course, with shorter or longer barrels the performance will decrease or increase, so you will move on to the harder or softer calibration.
The thickness due to the spring guide and piston head bearings was not taken into consideration in the calibration process.
For this reason, given the same initial conditions, an increase in performance of approximately must be taken into account 2.5 m/s for each bearing.
The FPS spring is 100% Made in Italy and was created in collaboration with leading companies in the sector.SKU: FPS-95 -
Control units and Mosfets, FPS, Internal and external parts of rifles, Internal parts of rifles
FPS Micro Mosfet (MICRO1)
Control units and Mosfets, FPS, Internal and external parts of rifles, Internal parts of riflesFPS Micro Mosfet (MICRO1)
Very small MOSFETs, conceived specifically for the reduced internal spaces of the replicas from Softair (MICRO1)
Measures in millimeters:
19.8 x 6.6 x 3.9100% MADE IN ITALY
SKU: MICRO1
